Remote access to ESP32
Below is one way to set up remote access to Samovar. All the settings can be done in a couple of minutes.
Below is one way to set up remote access to Samovar. All the settings can be done in a couple of minutes.
Beer mode in Samovar: the line-based program, eight step types, mashing methods (infusion, decoction, HI/HERMS/RIMS) and recipe import from BeerXML.
The purpose of the ESP32 pins is described. See the article for details.
Below you can see an example of the log from which Samovar builds its charts. You can hide any data series by clicking its line in the legend (at the bottom), for example the Boiler…
Before you start, make sure you have the current version of Arduino IDE installed. To install the ESP32 board in Arduino IDE, you need to go through a few steps: In Arduino IDE, open the “Preferences” window. To do this,…
A Samovar take-off program is a text set of commands that describes the controller’s behavior over time. Each line specifies a condition (sensor temperature, time, volume), an action (turn the pump on/off, change the speed,…
How to connect Samovar for remote control: a VPN to your home network, or the mobile apps and the samovar-tool.ru website without exposing the web interface to the internet.
The complete list of Samovar 7.00 emergency scenarios: temperature limits (steam, water, ACP), pressure, flooding sensor, water flow, sensor failure, emergency button, FreeRTOS watchdogs.
This page describes the full operating cycle of Samovar in “Rectification” mode: from power-on and column warm-up to the take-off of heads, hearts and tails and the automatic end of the program. The description applies…
All Samovar 7.00 parameters on the “Settings” page: seven tabs (Main, Temperatures, Pump, Beer, Cheese, CDC, Other), five DS18B20 sensors, PID, impurity detector, brewing order, MPX5010DP.