Working in manual mode

 

For this, you can set a single program line. For example, this one:

 

H;65535;0.10;0;0;120

 

The volume in the line cannot exceed 65535 ml, and the first program line must specify the voltage regulator voltage (power), otherwise take-off will not start.

 

After the "Turn on heating" («Включить нагрев») command, Samovar tells the regulator to start boosting. When the set temperatures are reached, Samovar turns on the water, finishes boosting and moves on to column stabilization. After you press "Start take-off" («Начать отбор»), Samovar goes to the program line above and works by it until it has taken off a virtual 65.5 liters at 100 ml/h (65.535/0.1 = 655 hours); while it does this, you can control the take-off parameters. You can change the take-off rate

 and the regulator voltage.

 

 The safety group, holding the set water temperature and the "Rectification, distillation and BK up to boiler temperature" («Ректификация, дистилляция и БК до температуры в кубе») setting will also work.

 

The temperature delta and thermometer excursions beyond the setpoint are not taken into account. On the heads line the impurity detector only observes. The sorting table rocker arm will stay in position No. 0 all the time.

 

Note:
You can switch to automatic program execution at any moment. Just add a program line for the required mode, run the "Set program" («Установить программу») command and then press "Next" («Далее») in the main window.