# How to Split Fruit Low Wines in Samovar 7.00 and Keep an Aromatic Hearts Cut

- Link: https://www.samovar-tool.ru/en/2026/09/23/split-fruit-low-wines-samovar-7/
- Published: 2026-09-23T07:15:05+03:00
- Author: kosoj.diy

# How to Split Fruit Low Wines in Samovar 7.00 and Keep an Aromatic Hearts Cut

When working with fruit raw material, you do not always need to send all the low
wines to deep rectification. Rectification gives clean high-proof spirit, but at
the same time removes a significant part of the fruit aroma.

A practical compromise: produce low wines, run a second distillation in “Distillation”
mode, separate a small aromatic portion (the hearts) and store it separately, and
send the rest of the product to rectification. Then the rectified spirit can be 
blended with the saved aromatic hearts.

![Apple low wines processing diagram](https://i0.wp.com/www.samovar-tool.ru/wp-content/
uploads/2026/09/image_002_1-2.jpg?w=1200&ssl=1)

## 1. Calculating the Initial Absolute Alcohol

50 L of cider at 8% ABV theoretically contains:

    ```
    50 × 8 / 100 = 4 L of absolute alcohol
    ```

The actual amount of absolute alcohol is determined from the low wines you actually
obtained:

    ```
    AA = low wines volume × low wines strength / 100
    ```

For example, for 12 L of low wines at 30%:

    ```
    12 × 30 / 100 = 3.6 L AA
    ```

## 2. First Distillation of the Cider

The first distillation is needed to obtain low wines. At this stage there is no 
point in aiming for high strength or in separating fractions finely. The goal is
to process the cider, get low wines and preserve the fruit aroma.

Samovar uses the “Primary distillation” mode. Take-off can continue until the alcohol
in the boiler runs out, either until only water is left or until the set boiler 
temperature limit is reached. When it finishes, measure the volume and strength 
of the low wines.

## 3. How to Determine the Size of the Hearts Cut to Keep

The hearts cut is set as a share of the absolute alcohol in the initial low wines,
not as a fixed volume of liquid.

If the low wines contain 3.6 L AA and you want to keep 12%:

    ```
    3.6 × 12 / 100 = 0.432 L AA
    ```

This is not 0.432 L of finished distillate. The liquid volume depends on its actual
strength.

## 4. Why the Hearts Percentage Is Calculated from Absolute Alcohol

At the start of the second distillation the take-off strength is higher, and then
it falls. So the share of liquid volume is not equal to the share of absolute alcohol.
Calculating via AA lets you set the target in terms of a material balance.

  |  Parameter |  Value |  
   |  Low wines |  12 L |  
 |  Strength |  30% |  
 |  Initial AA |  3.6 L |  
 |  Share to keep |  12% |  
 |  Target AA of the hearts |  0.432 L |

## 5. Principle of the Second Distillation Program

In “Distillation” mode Samovar uses lines of the form:

    ```
    Type;Value;Container;Voltage
    ```

The main condition types: `T` — boiler temperature; `A` — absolute alcohol strength
in the boiler; `S` — relative change in alcohol strength in the boiler; `P` — calculated
absolute alcohol strength of the take-off; `R` — relative change in alcohol strength
of the take-off.

The `P` condition is convenient for separating the aromatic hearts. The example 
below is calculated for a regulator where the power field is set in watts:

    ```
    T;85;0;1800
    A;80;1;0
    P;60.00;2;0
    P;57.18;1;0
    ```

Container 2 is for the hearts you keep, container 1 is for the rest of the product.

![Samovar 7.00 program logic](https://i0.wp.com/www.samovar-tool.ru/wp-content/uploads/
2026/09/image_003_1-2.jpg?w=1200&ssl=1)

## 6. How the Second P Threshold Was Obtained

The percentage of hearts to keep alone does not tell Samovar at which take-off strength
it should switch the container. For a preliminary calculation, a simplified batch
distillation model with a constant relative volatility coefficient `α` is used.

The example assumes `α = 4.0`. This is a conditional model parameter, not a universal
characteristic of the apparatus. The calculation is approximate: it is meant for
a starting program and must be checked against the actual log of the run.

To keep the material balance correct, the model calculates the composition in moles,
accounting for ethanol and water separately. With initial low wines of 12 L at 30%,
the start of the hearts at a calculated `P=60%` and a target of 0.432 L AA, the 
model gives the end of the hearts at approximately `P=57.18%`.

This threshold is not a chemical boundary between fractions. Samovar calculates 
alcohol strength mathematically, and the actual strength and composition of the 
product may differ. So after the run, record the volume, strength and sensory profile
of each fraction; then adjust the threshold for the next batch.

## 7. What to Send to Rectification

The heads, tails and the remaining part of the hearts that you do not plan to keep
go to rectification. The hearts you keep are not included in the column charge.

Before rectification, combine the fractions intended for the column and measure 
the total volume and strength. For example, for 10 L of remainder at 28%:

    ```
    10 × 28 / 100 = 2.8 L AA
    ```

## 8. Setting Up the Rectification Program

In rectification mode the lines have a different format:

    ```
    Type;Volume_ml;Speed_L_h;Container;Switch_temperature;Voltage
    ```

For fruit low wines, you can use as starting settings about 8% AA for heads, about
5% AA for tails and a target hearts strength of about 94%. These values are not 
universal norms.

For the example with 10 L of low wines at 28%, the calculated lines may look like
this:

    ```
    H;238;0.100;1;0;1700
    B;2591;0.400;2;0;0
    T;149;0.200;1;0;0
    ```

Here 1700 is power in watts for the SEM_AVR regulator. For a voltage-type regulator,
use the value in volts calculated for your particular heating element.

![Fruit spirit and a reflux column](https://i0.wp.com/www.samovar-tool.ru/wp-content/
uploads/2026/09/image_001_1-2.jpg?w=1200&ssl=1)

## 9. Why 94% Is a Target, Not a Guaranteed Strength

The actual strength depends on the diameter and height of the column, the packing,
power, take-off rate, cooling and the composition of the charge. So after rectification,
measure the strength and, if needed, adjust the power, speed and parameters of the
next program.

## 10. Blending the Rectified Spirit with the Aromatic Hearts

First, it is worth making small test blends with different shares of hearts, for
example 5%, 10%, 15% and 20% of the alcohol part. Bring the samples to the same 
strength of 43–45% and let them rest for at least a week.

## Summary Scheme

    ```
    50 L of cider 8%
    → first distillation until the alcohol runs out
    → measure the volume and strength of the low wines
    → second distillation
    → separately keep the calculated share of hearts
    → the rest goes to rectification
    → rectified spirit at about 94%
    → blend with the aromatic hearts
    ```

The main principle is to calculate the hearts to keep from the absolute alcohol,
not from the liquid volume. The program thresholds are calculated values and need
calibration for your particular apparatus.

## Samovar Documentation

 * [The “Distillation” program](https://www.samovar-tool.ru/doc/en/manual/programma__distillyatsiya.html)
 * [Rectification mode](https://www.samovar-tool.ru/doc/en/manual/rezhim_rektifikatsii.html)
 * [Take-off program in rectification mode](https://www.samovar-tool.ru/doc/en/manual/programma_otbora_rezhima_rektifikatsiya.html)
 * [Program calculation calculator](https://www.samovar-tool.ru/doc/en/manual/kalkulyator_rascheta_programmy.html)
 * [Heads take-off](https://www.samovar-tool.ru/doc/en/manual/otbor_golov.html)
 * [Hearts take-off](https://www.samovar-tool.ru/doc/en/manual/otbor_tela.html)

_This material describes the calculation logic and automation setup. Before working
in practice, take into account the design of your setup, the condition of the equipment,
ventilation, fire safety and the current rules on the production and handling of
strong alcoholic beverages._

### Like this:

Like Loading…

### _Related_
